Show Posts
1
General Discussion / Re: Modded gpx settings
« on: June 16, 2016, 08:17:11 pm »
Evening all
After a weekend out and about I'm beginning to doubt my ability, my settings, and my sanity!
I've got the mods pre variable frequency update.
I found a screaming piece of rust (1mm x 3mm) on the surface early in the day. After finding a couple of .22 cases and the beloved boot tacks also on the surface without so much as a whoo hoo, I got curious as to the depth performance of my detector.
After burying the rust ~15cm down I began to test.
#1
Fine Gold / Sens Smooth / Sens Extra
Stabiliser:1
Rx gain: 1
Front end gain: Almost full
New timings: S / M / D
Result: Not a peep
#2
Normal
Stabiliser:1
Rx gain: 1
Front end gain: 1/2 to 3/4
Result: Heaps of background, but huge response.
Tried with both Coiltek 14"x9" Gold Stalker mono and 14"" Coiltek elite round mono (camo).
Some help / suggestions / humorous banter would be appreciated!
After a weekend out and about I'm beginning to doubt my ability, my settings, and my sanity!
I've got the mods pre variable frequency update.
I found a screaming piece of rust (1mm x 3mm) on the surface early in the day. After finding a couple of .22 cases and the beloved boot tacks also on the surface without so much as a whoo hoo, I got curious as to the depth performance of my detector.
After burying the rust ~15cm down I began to test.
#1
Fine Gold / Sens Smooth / Sens Extra
Stabiliser:1
Rx gain: 1
Front end gain: Almost full
New timings: S / M / D
Result: Not a peep
#2
Normal
Stabiliser:1
Rx gain: 1
Front end gain: 1/2 to 3/4
Result: Heaps of background, but huge response.
Tried with both Coiltek 14"x9" Gold Stalker mono and 14"" Coiltek elite round mono (camo).
Some help / suggestions / humorous banter would be appreciated!